![]() Ppp Start IETF Point-to-Point Protocol (PPP) Name-connection Name an existing network connection Mtrace Trace reverse multicast path from destination to source Mstat Show statistics after multiple multicast traceroutes Mrinfo Request neighbor and version information from a multicast Modemui Start a modem-like user interface Help Description of the interactive help system Nov 26 16:26:41.062: %LINK-5-CHANGED: Interface Serial1/1, changed state to admiĪccess-enable Create a temporary Access-List entryĪccess-profile Apply user-profile to interfaceĭisconnect Disconnect an existing network connection Nov 26 16:26:41.062: %LINK-5-CHANGED: Interface Serial1/0, changed state to admi Nov 26 16:26:41.062: %LINK-5-CHANGED: Interface Serial0/1, changed state to admi Nov 26 16:26:41.062: %LINK-5-CHANGED: Interface Serial0/0, changed state to admi Nov 26 16:26:41.062: %LINK-5-CHANGED: Interface FastEthernet0/0, changed state t Nov 26 16:26:41.046: %SNMP-5-COLDSTART: SNMP agent on host Router is undergoing Technical Support: Support and Documentation - Cisco SystemsĬopyright (c) 1986-2008 by cisco Systems, Inc. IOS (tm) C1700 Software (C1700-IPVOICE-M), Version 12.3(26), RELEASE SOFTWARE (f ![]() Nov 26 16:26:41.002: %SYS-5-RESTART: System restarted -Ĭisco Internetwork Operating System Software Nov 26 16:23:33.070: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEtherne Nov 26 16:23:31.623: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEtherne Nov 26 16:23:2EPROTO-5-UPDOWN: Line protocol on Interface Serial1/1, changed sta Then I then typed enable and it changed modes like it was supposed too. The guide I'm using told me to look at the commands when entering a"?". This is RIGHT after the last part I showed in my second post. here is what I got when I typed in those commands. i downloaded putty but haven't tried it yet. So to make my very long story short why is the enter button not doing a damn thing besides going to the next line down. So i hit it again, same, after working on just getting to this point for 2.5 hours (first router needs some help I guess messed with that for about 45 minutes) i just calmly turned everything off and went to bed. So i finally get to where I can type and I no to the first questions the router asked and hit and.it goes down a line and nothing.so i hit it again same thing. Alan2308 on here is kinda mentoring me through this whole beginning process and he gave me a link with some beginning commands. So after finally figuring (well searching Google.lol) out how to see what I was typing I think I'm ready to go. So after kinda getting my lab going last night I decided to fool around with one of 1760 routers a little bit (I have absolutely no experience with Cisco besides putting this lad together and very limited networking experience). I saw something on this while looking for another problem with hyperterminal last night but when I ran into this problem I couldn't find the information again. I have searched all over the place for an answer for this.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |